A recent spin on securing vises My idea is a simple mechanical device for preventing a drill-press vise from spinning.

A recent spin on securing vises

My idea is a simple mechanical device for preventing a drill-press vise from spinning. This owner leaves the operator free to use individual hand for the drill-press fe handle and the other to divert off the motor.

I drill and tap a 1/2-in. cavern in the outside face of a vise's fixed jaw. In the drill pres table at the exterior end, I drill and ream a aperture to fit a short, vertical pillar that is threaded at the bottom for a nut and washer. This pillar is shouldered in the way that that it can rotate after tightening the nut single in kind end of a long shoot screws into the ...

...